Be able to edit events from Organization or Facility list

Assume I go into Information / Facilities / (select one) / List of Events. This brings up a nice list, and I can click "load event" for more information. I would really like that to make changes to the event after I have "loaded" it rather than having to back out, go to Information / Events / etc...

I don't always know how an event is named in the event list, so it is easiest to just run the quick list by facility (or organization) instead of searching in the all event list.

Mary Nordstrom

13 Posts
2 Reply Likes

Posted 2 years ago

2 years ago

Adrienne Coerper

37 Posts
3 Reply Likes

I agree there should be an "edit" button right on this screen.

However, I have noticed that once you are on this screen, and then close it - if you click the "Events" button immediately afterward, it *usually* will bring up that same event that you were looking at without having to search for it again.

Comment

2 years ago

Karen Komlos, Official Rep

270 Posts
31 Reply Likes

Hi Mary and Adrienne. You may edit on the Load Events screen. Just put your cursor in the field you wish to change and make the change. When you do, the button in the bottom right corner will change from "Close" to "Save" and "Cancel" allowing you to either save your changes or cancel them. It's a slightly older interface, and may not seem intuitive if you are relatively new to the Facility Scheduler program (within a few years). Hope this helps.

Comment

2 years ago

Adrienne Coerper

37 Posts
3 Reply Likes

Hi Karen-
Yes, you can change the Organization or Event Name, but the Facility Name and Date and Times cannot be edited from the "Load Event" window. If you try to change one of these fields, you get a popup message that says "This field is view only. To change this value, go to the Event Window"